WPB 109 Wallplate • Installation Guide
AUDIO
The Extron WPB 109 wallplate is a single gang
pass-through wallplate with audio, VGA, and HDMI
connectors and 10-inch pigtails. It can be installed in
the supplied single gang mud ring or a junction box.
COMPUTER
HDMI
Install the wallplate directly into the wall using the
supplied mud ring or a UL-approved 1-gang junction
box (not supplied). Follow the steps in the “Installation”
section.
WPB 109
Front
Side
Planning - Check the Proposed Installation Location
Before starting the installation it is important that you do the following:
WARNING: Failure to check these items may result in property damage, personal injury,
or both.
Ensure there are no utility cables or pipes at the intended location that might be damaged
or cause injury when you are installing the device.
c
c
Check that the installation meets the local and state regulatory requirements, including
building, electrical, and safety codes, and UL and ADA accessibility requirements.
During installation ensure the space behind the device is sufficient for the bend radius of the
pigtail. The recommended minimum bend radius is 2.4 inches.
Installation
1. Using the supplied mud ring or a junction box (not included) as a guide, mark and cut out
the appropriate material within the marked area.
2. Either:
Locking Arms
z
z
Insert the mud ring into the opening, rotate the
locking arms, and secure it with the supplied screws
(as shown at right), or
Wall Mounting
Bracket
Insert the junction box and secure it with nails or
screws.
O
AUDI
3. Run the cables (video, audio, and HDMI) from the output
or input device locations (as applicable), behind the wall,
and to the WPB location, then thread the cables through
the mud ring or junction box.
COMPUT
I
HDM
WPB 109
Extron
WPB 109
4. Video — Insert the HDMI and VGA cable connector into
the appropriate connector on the pigtail.
NOTE: If using a DVI display with the WPB 109, connect a HDMIM-DVIDF adapter (part
number 26-617-01) and a separate audio cable.
5. Audio — Secure the output audio cable into the 3-pole captive screw connector. Wire as
described in “Cable Preparation for Audio Connections” on page 2.
NOTE: This may be easier to do before attaching the device to the mud ring.
6. Mount the cabled device into either the mud ring or the junction box.
CONTINUED ON SIDE 2
1
|
Clarion CD Player DB415 User Manual
Cornelius Beverage Dispenser Quest 2000 User Manual
Cuisinart Coffeemaker WCM 11SA User Manual
Cuisinart Waffle Iron GR WAFP User Manual
Cuisinart Waffle Iron WAF RC User Manual
Delta Electronics Network Card SPBD 1250A4Q1RT User Manual
DigiTech Portable Speaker RP300A User Manual
Dixon Lawn Mower 539 131354 User Manual
Dynex Microphone DX 54 User Manual
Fisher CRT Television PC 25S00 PC 27S90 User Manual